Inspection / Tune Up

Service Description

All payments are due upon completion of service 24-Point Check-Up Trained Specialty HVAC technicians will perform a 60-90 minute tune-up 24 procedures: Blower Motor – measure amperage and voltage for proper operation Thermostat – test for proper operation, calibrate, and level Cleaning existing air filter (as needed) Bearing – inspect for wear and lubricate Inspect indoor coil if accessible Inspect Condenser Coil Refrigerate – monitor operating pressures Safety Devices – inspect for proper operation Electrical Disconnect Box – inspect for proper rating and safe installation Electrical Wiring – inspect and tighten connections Test/inspect contactors for burned, pitted contacts Inspect electrical for exposed wiring Inspect and test capacitors Inspect fan blade Clean condenser (remove debris only) Inspect service valves for proper operation Measure Supply/Return temperature differential Compressor – monitor, measure amperage and volt draw and wiring connections Check Unit for Time Delay Relay Check Unit for Isolation Pads Inspect suction line for proper fittings Inspect all fittings for signs of oil and/or leakage Check lines and fittings with refrigerant leak detector Check the condition of Blower Belt, if applicable